纳米SnO_2固体的相变内耗和模量

系统测量了不同颗粒尺度纳米 SnO_2固体的内耗和模量,发现60℃附近存在一个内耗峰,对应的模量出现异常.烧结温度升高,峰高变化不明显,模量异常减弱.当烧结温度高于400℃时,模量曲线在-15℃附近出现异常,这种模量异常随烧结温度升高而加强,对应的内耗曲线出现一小峰.初步认为,60℃附近内耗峰和模量异常与纳米固体中的结构再有序有关,而-15℃处的模量异常为结构相变引起.     

宽带智能天线系统中的频率补偿技术

在无线通信中,智能天线系统在抑制窄带多径干扰方面具有得天独厚的优势,但是用于宽带无线通信系统中时,就需要采用频率补偿方法.重点介绍基于频谱分解、聚焦和插值算法的补偿技术,并对这3种频率补偿技术的性能进行比较,结果表明在应用补偿技术的系统中,系统性能有显著的改善,其中插值算法具有最优的性能.     

Determination of Boundary Shear Stress and Reynolds Shear Stress in Smooth Rectangular Channel Flows

A method for computing three-dimensional Reynolds shear stresses and boundary shear stress distribution in smooth rectangular channels is developed by applying an order of magnitude analysis to integrate the Reynolds equations. A simplified relationship between the lateral and vertical terms is hypothesized for which the Reynolds equations become solvable. This relationship has the form of a power law with an exponent of n = 1, 2, or infinity. The semiempirical equations for the boundary shear distribution and the distribution of Reynolds shear stresses are compared with measured data in open channels. The power-law exponent of 2 gave the best overall results while n=infinity gave good results near the boundary.     

Investigation of Boundary Shear Stress and Pollutant Detachment from Impervious Surface during Simulated Urban Storm Runoff

Pollutant detachment rates have been determined for four chloride salts during simulated urban storm runoff. Under rainfall and/or overland flow conditions, chloride mass flux was measured and related to boundary shear stress of the test surface. Washoff coefficients, presumed to depend only on pollutant characteristics, were computed based on the slopes of dimensionless mass flux versus dimensionless time plots. Washoff coefficients were found to vary among and between the chloride compounds studied. In general, higher overland flow rates produced lower boundary shear and lower washoff coefficients. The combination of simulated rainfall and overland flow resulted in an increased boundary shear and an increased washoff coefficient. An empirical washoff coefficient based on a load characteristic curve derived from an exponential washoff relationship was also computed from the runoff data and compared with the previous washoff coefficient. A linear correlation between these two washoff coefficients was observed. The magnitude of the latter coefficient under simulated rainfall was consistent with reported values obtained from field data.     

Suppression of void coalescence in thermal aging of tin-silver-copper-X solder joints

Addressing the potential for drop impact failure of Pb-free interconnects, the shear ductility after extensive aging of Sn-Ag-Cu (SAC) solders has been improved radically by Co or Fe modifications. Several other SAC+X candidates (X=Mn, Ni, Ge, Ti, Si, Cr, and Zn) now have been tested. Solder joint microstructures and shear strength results show that new SAC+X alloys also suppress void formation and coalescence at the Cu (substrate)/Cu₃Sn interface (and embrittlement) after aging at 150°C for up to 1,000 h. Microprobe measurements of 1,000 h aged samples suggest that Cu substitution by X is usually accentuated in the intermetallic layers, consistent with X=Co and Fe results.     

工字梁的抗剪极限承载力

对工字梁腹板抗剪极限承载力的研究进行总结,对各种公式与文献中的试验结果进行对比,将拉力场理论和转向应力场理论的假定与ANSYS分析揭示的腹板应力发展变化规律进行对比,指出了假定和数值分析结果的不一致。提出了翼缘对腹板转动约束的合理参数,得到精度良好的考虑翼缘约束的腹板剪切屈曲系数。利用得到的屈曲系数,考虑翼缘抗弯承载力的贡献,提出新的工字梁抗剪极限承载力的计算公式。与现有试验数据和ANSYS非线性有限元分析结果的对比,证实建议方法离散性较小,适用范围广,尤其是对于通用高厚比较大的梁,较以往方法有了较大改进。     

混凝土大坝导温系数反演及其随时间变化的规律

随着时间的推移,混凝土的导温系数将发生变化,为了了解参数随时间的变化规律,利用原型观测资料对导温系数进行分段反演,从而拟合出大坝混凝土导温系数随时间的变化规律.     

Effects of weak shear on hyperswollen lyotropic smectic liquid crystals

We have developed a Zimm-type viscometer specially designed for the simultaneous measurements of the structure factor and the viscosity of hyperswollen lyotropic liquid crystals under a very weak shear. We have investigated the shear effects on the layer undulation fluctuation in the lamellar structure and the transition from the anisotropic lamellar to the isotropic sponge phase. We have found a significant difference in the rheological properties between the lamellar and the sponge phase: The former exhibits non-Newtonian flow behavior, while the latter exhibits Newtonian behavior.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.     

钢筋混凝土框架-剪力墙结构在强震作用下的非线性分析——Ⅱ、程序及算例

运用文献[1]所介绍的分析原理与方法,编制了强震作用下钢筋混凝土框架-剪力墙结构非线性地震反应时程分析的程序。本文介绍该程序的功能、框图,以及利用该程序计算所得到的几栋钢筋混凝土结构的非线性地震反应分析结果。算例表明,本程序计算结果可靠,能很好地用于解释震害和预测地震时结构可能发生的破坏。     

Pb/Sn凸剪切性能研究

在实际使用条件下,Pb/Sn凸点会由于承受温度循环而产生剪切应力,剪切应力导致的主要失效方式是开裂.通过对倒装焊后Pb/Sn凸点剪切强度的测量及对剪切后断口的分析,发现破坏主要发生在凸点下金属(UBM)层内部或UBM与Al焊盘之间,平均剪切强度受凸点尺寸影响很小,范围在21～24MPa。